Hard capsule filling machine model operation steps:
1. Press the green button in the “Power Switch†and the power is turned on.
2. Slowly adjust the “Vibration Strength Adjustment Knob†and rotate it clockwise. At this time, the finishing disc that is integrated with the “Vibration Bracket†starts to vibrate, touch the finishing disc by hand, and adjust to a certain oscillation intensity by feeling.
3. Put the powdered capsule shell into the “Powder Capsule Shell Finishing Plateâ€, about 300 capsules each time. Put the capsule cap into the "capsule cap finishing tray", about 300 capsules each time. The finishing disc is made of plexiglass plate, and a plurality of round holes with a large upper and lower funnel shape are drilled thereon, and the diameter of the circular hole corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibration table plate is moved slowly before and after, so that it enters the hole of the platen one by one.
4. For about 30 seconds, the powder capsule shell and capsule cap will fall into the round hole with the opening facing up. If the individual opening is facing down, the capsule cap can be pressed down gently to fit out.
5, horizontal hand-held powder capsule shell plate (pictured at the end, has been randomly prepared, there are round holes in the board), gently push in the lower part of the tray, tidy up the powder capsule shell in the tray It will fall down into the hole in the plate and then remove the plate. In the same way, the capsule cap is removed with a capsule cap.
6. A prescription powder plate with a bottom area of ​​500×500mm2 and a height of about 10mm on the four sides can be prepared in advance, and the powdered capsule is placed in the square plate of the powder powder. Then, the randomly arranged plexiglass frame is placed on the powder-filled capsule board, and the small shovel shovel powder is put into the frame, and the powder is scraped with the frame edge to fill the powder, and the excess powder is scraped off.
7. Use the matching capsule cap to set the plate (the end of the figure is drawn, there is a round hole on the set plate), put it on the capsule cap plate, and there is a matching hole, which is easy to place. Flip the cap of the capsule cap so that the opening of the capsule is facing down, and it is placed on the shell plate of the powdered capsule with the powder installed. There is also a matching hole, which is easy to fit.
8. Put the nested capsule plate into the cavity under the “capsule cap forming plateâ€, and pull the “pressing bar†down by hand and put it in place, no need to be too strong, because there is a positioning mechanism to control the pressing height. Remove the capsule plate, pour out the capsule, and fill it. You can cycle through the next board.
Hard Capsule Filling Machine Model Maintenance Precautions:
1. This equipment is a vibration machine. Always check the tightening of the screws at each part. If it is loose, tighten it in time to prevent malfunction and damage.
2, plexiglass parts (workbench board, medicine board) should avoid direct sunlight and close to high temperature, do not put heavy objects, the medicine board must be placed vertically or flat to avoid deformation and damage.
3. The electrical enclosure and the fuselage must be grounded to ensure safety and the power is cut off after the work is completed. .
4. After the work is completed every day, the residual drugs in the machine and the mold hole should be cleaned to keep the machine clean and hygienic, and avoid washing the host with water. If the mold on the machine needs to be cleaned, the screw can be loosened and it can be taken down for easy installation.
Angiography Control Syringes
Angiography Control Syringes,Angiography,angiography system,angiography machine
Anesthesia Medical Co., Ltd. , https://www.jssinoanesthesia.com