Explain the operation of dehydrated vegetable belt dryer

Explain the operation of dehydrated vegetable belt dryer

The material processed by the dryer is discharged from the inside, and the mesh belt is cleaned by the net belt when returning, and then the impurities are removed by the miscellaneous device, and the whole process is cleaned by the cleaning device at the other end, but in practice During the operation, there will be some problems, so we need to pay attention to it.

Dehydration vegetable belt dryer operation problem:

1. Inspect and maintain the components of the belt dryer. For example, add lubricant to the bearing, adjust the pulley, check the electrical circuit, the rocker arm of the door, the pipe joint, etc. and fix it.

2, the raw material fire failure, may be the design problem of the dryer, or the raw materials can not be sucked to cause fire in the dryer. In addition, it may also be caused by human factors, such as the forced heating of a dryer that is too small to achieve a drying effect. At this time, Zui is good to replace the dryer equipment, check whether the dryer is installed correctly, whether it leaks or increases the wind pressure. Use the dryer properly and carefully increase the temperature of the dryer to avoid ignition.

3. There is a problem that the raw materials are not dried at one time, which is mainly caused by the reason that the dryer is too small or the dryer is improperly used. In addition, wind network wind pressure and flow calculation errors can also cause such failures. The drying equipment can be replaced or re-modified, or the manufacturer is required to recalculate the wind pressure, flow and other changes. If it is caused by improper operation, the operator will operate in strict accordance with the instructions.

4. Ensure that the fixing bolts of the dewatering vegetable belt dryer are not loose, the support springs are tightly connected, and the control of the computer board, the wind wheel and the heat exchanger have good flexibility. Keep the equipment clean, wipe the equipment daily, and clean the fluff inside the dust box to ensure ventilation. Regularly open the rear cover to clean the inside of the device.