(1) The incubator should be installed on the concrete floor. The ground should be kept flat. When installing, the incubator should be slightly forward (some models backward) so that the sewage can be discharged during cleaning, leaving 2 to 3 in front of the machine. Meter's operating space.
(2) The temperature of the incubator should be maintained at 20 to 27 degrees Celsius. When the temperature is higher than 27 degrees Celsius or less than 20 degrees Celsius, air-conditioning equipment or other measures should be considered. Humidity should be maintained at about 50 percent. Indoors should have good ventilation and ventilation conditions. Incubator (especially the exhaust gas from the hatching machine should be led to the outside by the pipeline. The incubator room should be frequently cleaned, washed, painted and disinfected.
(3) After the whole machine is installed, it is necessary to power on the test machine to check whether the temperature and humidity control system is normal and adjust the temperature according to the requirements. Also check whether there is any fault in the over-temperature or low-temperature alarm system. The automatic timing egg-turning system is normal and waits for 1 to 2 days. After all the normal conditions, it can be officially hatched.
(4) Observe the temperature indicated by the thermometer on the door at any time during use. If any abnormal phenomenon occurs, check the temperature control system in time and troubleshoot.
(5) As the embryonic age grows, the air inlet and exhaust port should be properly opened, and all of them should be opened later to ensure the normal development of the embryo for oxygen. However, the early stage should not be opened too large to avoid slow heating and waste. Electric energy.
(5) It should be noted whether the turning angle of the egg meets the requirements and whether the timing is accurate. It is better to make all the hatching machines turn the same direction in order to facilitate management. Record every time you turn the egg.
(7) Attention should be paid to the fact that the water tank (disc) of the humidity control device must not be cut off, and the gauze and water tank of the sensing element must be changed frequently. After the gauze is contaminated with dirt, it must be washed and reinstalled. For an incubator without an automatic humidity control device, it is necessary to warm the water in the water tray at regular intervals and adjust the number of water trays according to the requirements of the humidity during different incubation periods to ensure the humidity requirements of the embryo development.
(8) Thoroughly flush and disinfect the incubator or hatcher after each batch or group of hatches. Then check whether the mechanical part is loose or stuck, check the condition of the oil in the reducer, and remove the dust, villi and other dirt on the electrical equipment. Power test run for a period of time, adjust the temperature and humidity and then incubate the next batch.
We offer modified Pp Resin materials for you .Among the raw materials we use, some kinds are imported medical-level pellets and some are chinese local raw materials.We can manufacture the products as clients need. Our products can be used for injection packing products, such as PP joint for transfusion bag , Pp Cap for medical container etc. More details, pls contact us as soon as possible. We are looking forward to cooperate with you and wish offer the best products to you.
PP Resin For Outer Cap/inner Cap
Pp Resin For Outer Cap,Pp Resin For Inner Cap,Pp Homo Polymer Resin,Pp Resin For Pp Caps
SUZHOU CRH PHARMACEUTICAL TECHNOLOGY CO.,LTD , https://www.crh-health.com