When clutch slip occurs, correct fault analysis should be performed.
(1) Causes of slipping of the clutch 1 Excessive wear of the friction plate of the driven plate or exposure of the rivet;
2 Clutch pressure plate spring too soft or broken;
3 The free travel of the clutch pedal is too small;
4 There is oil on the driven plate friction plate or aging hardens;
5 loose clutch and flywheel engagement bolts;
6 Clutch master cylinder return port blocked.
(2) Troubleshooting sequence and side 1 Check pedal free travel, if not meet the standard value, should be adjusted;
2 If the free travel is normal, remove the bottom cover of the clutch and check if the clutch cover and the flywheel joint bolt are loose. If there is any looseness, it should be tightened;
3 Look at the edge of the clutch friction plate for oil spillage. If there is oil, remove it with gasoline or alkaline water and dry it. Then find the source of the oil stain and remove it.
4 If it is found that the friction plate is seriously worn out, the rivet exposed, aging hardened, burned and soaked by oil, the new film should be replaced. The replacement of the new friction plate must not be cracked or damaged. The depth of the rivet should comply with the regulations;
5 Check the oil return hole of the clutch master cylinder. If the return oil hole is blocked, clear it;
6 If the above inspection, adjustment and repair still fail to solve the problem, disassemble the clutch and check the spring force of the pressure plate spring. Pressure plate spring is good, the length should be consistent, such as uneven, should replace the new products, such as a slight reduction in elasticity, the length difference is not large, can be adjusted under the spring to adjust the gasket.
[Composition]
The main component of this
preparation is human immunoglobulin, which is prepared by cold ethanol
fractionation of human plasma from healthy donors. The manufacturing process
contains a step to remove anticomplementary activity and a dual viral
inactivation process. It contains a suitable amount of glucose or maltose as
stabilizer (see table below), but does not contain any antiseptic or
antibiotic. The distribution of IgG subclasses is close to the serum level of
normal subjects and maintains the bioactivity of Fc fragment of IgG.
[Indications]
1. Primary
agammaglobulinemia, such as X-linked hypogammaglobulinemia,
common variant immunodeficiency diseases, immunoglobulin G subclass deficiency,
etc.
2. Secondary
immunoglobulin deficiency diseases, such as severe infection, septicemia of
newborn, etc
3. Autoimmune diseases,
such as primary thrombocytopenic purpura, Kawasaki disease
Intravenous Injection Of Human Immunoglobulin
Intravenous Injection Of Human Immunoglobulin,Intravenous Immunoglobulin,High-Quality Effective Intravenous Immunoglobulin,Human Immunoglobulin For Intravenous Injection
Sichuan Yuanda Shuyang Pharmaceutical Co., Ltd. , http://www.syimmunoglobulin.com